ACI: Create a tenant and VRF

(This is from ACI Built in Help)

If you have a public subnet when you configure the routed outside, you must associate the bridge domain with the outside configuration.

1. On the menu bar, click TENANT > Add Tenant.
2. In the Create Tenant dialog box, perform the following tasks:
   1. In the Name field, enter a name.
   2. Click the Security Domains + icon to open the Create Security Domain dialog box.
   3. In the Name field, enter a name for the security domain. Click Submit.
   4. In the Create Tenant dialog box, check the check box for the security domain that you created, and click Submit.
3. In the Navigation pane, expand Tenant-name > Networking, and in the Work pane, drag the VRF icon to the canvas to open the Create VRF dialog box, and perform the following tasks:
   1. In the Name field, enter a name.
   2. Click Submit to complete the VRF configuration.
4. In the Networking pane, drag the BD icon to the canvas while connecting it to the VRF icon. In the Create Bridge Domain dialog box that displays, perform the following tasks:
   1. In the Name field, enter a name.
   2. Click the L3 Configurations tab.
   3. Expand Subnets to open the Create Subnet dialog box, enter the subnet mask in the Gateway IP field and click OK.
   4. Click Submit to complete bridge domain configuration.
5. In the Networks pane, drag the L3 icon down to the canvas while connecting it to the VRF icon. In the Create Routed Outside dialog box that displays, perform the following tasks:
   1. In the Name field, enter a name.
   2. Expand Nodes And Interfaces Protocol Profiles to open the Create Node Profile dialog box.
   3. In the Name field, enter a name.
   4. Expand Nodes to open the Select Node dialog box.
   5. In the Node ID field, choose a node from the drop-down list.
   6. In the Router ID field, enter the router ID.
   7. Expand Static Routes to open the Create Static Route dialog box.
   8. In the Prefix field, enter the IPv4 or IPv6 address.
   9. Expand Next Hop Addresses and in the Next Hop IP field, enter the IPv4 or IPv6 address.
   10. In the Preference field, enter a number, then click UPDATE and then OK.
   11. In the Select Node dialog box, click OK.
   12. In the Create Node Profile dialog box, click OK.
   13. Check the BGP, OSPF, or EIGRP check boxes if desired, and click NEXT. Click OK to complete the Layer 3 configuration.
   To confirm L3 configuration, in the Navigation pane, expand Networking > VRFs.